無線測溫產品在北京大興國際機場的應用CE RED證書歐盟出口

更新時間：2023-04-26 點擊次數：424次

摘要：隨著電力工業的發展，對設備的可靠性要求越來越高。在這種條件下，高壓設備的無線測溫系統應運而生。這種技術是將內置電池或電流感應和無線發射模塊的測溫傳感器安裝于各測溫點，由于其體積小，且無需任何接線，其電氣可以得到保證。傳感器周期性的將測溫數據無線發送至接收單元，接收單元可聯網將數據送至主站，以此實現一個區域系統的電氣溫度監測。本文介紹了安科瑞無線測溫產品在北京大興國際機場的應用。

Abstract: With the development of the electrical industry, the re for the safety and reliability of e are getting higher and higher. Under this condition, a wireless temperature measurement system for high-voltage e came into being. It is to install temperature sensors with batteries or CT powered at each temperature measurement point. The sensor sends the temperature measurement data to the receiving unit, and the receiver can be connected to the system to realize the electrical temperature monitoring. This article introduces the application of Acrel wireless temperature measurement products in Beijing Daxing International Airport.

關鍵詞：無線測溫傳感器，無線測溫系統，高壓柜

Keywords: Wireless Temperature Sensor, Online Temperature Monitoring System, High-voltage Switchgear

1.Project Overview項目概述

北京大興國際機場建設在北京市大興區與河北省廊坊市廣陽區之間，是超大型國際航空綜合交通樞紐。該機場航站樓高壓變電站分為三個部分：開閉站，指廊和核心區，其中，開閉站包括116面高壓柜，指廊包括40面高壓柜，核心區包括80面高壓柜，以及其他配電部分包括430面高壓柜。安科瑞為其提供了無線測溫解決方案，每面高壓柜斷路器上下觸頭、電纜接頭9點測溫，共668面高壓柜，無線測溫傳感器共計6015點。每面高壓柜安裝一臺ASD320智能操控裝置。

As a large international transportation hub, Beijing Daxing International Airport is located between Beijing Daxing District and Guangyang District, Langfang City, Hebei Province. The airport terminal high-voltage substation includes 668 high-voltage cabinets. Acrel provided it with a wireless temperature measurement solution. The upper and lower contacts and cable joints of each high-voltage cabinet were tested at 9 points. There were a total of 6015 wireless temperature sensors. At the same time, it should be installed an ASD320 intelligent control device on each high-voltage cabinet.

2.Introduction of Wireless Temperature Measurement Products無線測溫產品介紹

電氣接點無線測溫產品適用于中低壓開關柜內電纜接頭、斷路器觸頭、銅排，室內橋架、電纜，以及設備表面等場所的溫度監測，及時、持續、準確反映設備運行狀態，提高設備保障。

Wireless temperature measurement products are suitable for temperature monitoring of cable joints, circuit breaker contacts, copper bars, cables, and e surfaces in medium-voltage and low-voltage?switchgear, and reflect the operating status of e in a timely, continuous and accurate manner to improve the safety on e.

3.Introduction of Acrel Wireless Temperature Measurement Solution安科瑞無線測溫解決方案介紹

3.1 Solution for High-voltage and Low-voltage Switchgear (With display)